Scope of applicationVoltage: 110V/60HzMaterial: Stainless steel surfaceWorking principle: PneumaticFilling volume (ml): 10~100ml, 100~1000ml, 3~30ml, 30~300ml, 5~50ml, 50~500mlFilling accuracy (FS): 0.5% Production capacity (cycle/minute): 1-25Applicable tolerance (m3/min): 0.1Applicable pressure (Mpa): 0.4-0.9Use power and gas sources that meet the requirements of this machine.

Under continuous working conditions, the stability of the gas source must be maintainedBefore disassembling, cleaning or repairing the machine, be sure to turn off the gas source and power supplyThe electrical control components are installed in the rear half of the machine (near the control button) and the lower part of the frame. Do not rinse the machine body directly with water under any circumstances, otherwise there is a risk of electric shock and damage to the electrical control components.

After turning off the power switch, the machine electrical control circuit still has voltage. When repairing the control circuit, be sure to unplug the power cord. Before filling the material, it is best to clean the machine with a detergent and then rinse it with clean water to prevent oil or foreign matter from mixing into the material, causing material waste and machine damage.